The CPUWAIT register acts as a sort of power-control: if a bit
in it is 1 then the CPU will have been forced into waiting
when the system was reset (which in QEMU we model as the
CPU starting powered off). Writing a 0 to the register will
allow the CPU to boot (for QEMU, we model this as powering
it on). Note that writing 0 to the register does not power
off a CPU.
For this to work correctly we need to also honour the
INITSVTOR* registers, which let the guest control where the
CPU will load its SP and PC from when it comes out of reset.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20190219125808.25174-8-peter.maydell@linaro.org
The SYSCTL block in the SSE-200 has some extra registers that
are not present in the IoTKit version. Add these registers
(as reads-as-written stubs), enabled by a new QOM property.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20190219125808.25174-7-peter.maydell@linaro.org
The iotkit-sysctl device has a register it names INITSVRTOR0.
This is actually a typo present in the IoTKit documentation
and also in part of the SSE-200 documentation: it should be
INITSVTOR0 because it is specifying the initial value of the
Secure VTOR register in the CPU. Correct the typo.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20190219125808.25174-6-peter.maydell@linaro.org
The Arm IoTKit includes a system control element which
provides a block of read-only ID registers and a block
of read-write control registers. Implement a minimal
version of this.
Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Message-id: 20180820141116.9118-9-peter.maydell@linaro.org
