qemu-patch-raspberry4/hw/timer/cmsdk-apb-timer.c
Peter Maydell 1a9b30646e hw/timer/cmsdk-apb-timer: run or stop timer on writes to RELOAD and VALUE
If the CMSDK APB timer is set up with a zero RELOAD value
then it will count down to zero, fire once and then stay
at zero. From the point of view of the ptimer system, the
timer is disabled; but the enable bit in the CTRL register
is still set and if the guest subsequently writes to the
RELOAD or VALUE registers this should cause the timer to
start counting down again.

Add code to the write paths for RELOAD and VALUE so that
we correctly restart the timer in this situation.

Conversely, if the new RELOAD and VALUE are both zero,
we should stop the ptimer.

Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
Reviewed-by: Richard Henderson <richard.henderson@linaro.org>
Tested-by: Guenter Roeck <linux@roeck-us.net>
Message-id: 20180703171044.9503-5-peter.maydell@linaro.org
2018-07-09 14:51:34 +01:00

270 lines
7.8 KiB
C

/*
* ARM CMSDK APB timer emulation
*
* Copyright (c) 2017 Linaro Limited
* Written by Peter Maydell
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 or
* (at your option) any later version.
*/
/* This is a model of the "APB timer" which is part of the Cortex-M
* System Design Kit (CMSDK) and documented in the Cortex-M System
* Design Kit Technical Reference Manual (ARM DDI0479C):
* https://developer.arm.com/products/system-design/system-design-kits/cortex-m-system-design-kit
*
* The hardware has an EXTIN input wire, which can be configured
* by the guest to act either as a 'timer enable' (timer does not run
* when EXTIN is low), or as a 'timer clock' (timer runs at frequency
* of EXTIN clock, not PCLK frequency). We don't model this.
*
* The documentation is not very clear about the exact behaviour;
* we choose to implement that the interrupt is triggered when
* the counter goes from 1 to 0, that the counter then holds at 0
* for one clock cycle before reloading from the RELOAD register,
* and that if the RELOAD register is 0 this does not cause an
* interrupt (as there is no further 1->0 transition).
*/
#include "qemu/osdep.h"
#include "qemu/log.h"
#include "qemu/main-loop.h"
#include "qapi/error.h"
#include "trace.h"
#include "hw/sysbus.h"
#include "hw/registerfields.h"
#include "hw/timer/cmsdk-apb-timer.h"
REG32(CTRL, 0)
FIELD(CTRL, EN, 0, 1)
FIELD(CTRL, SELEXTEN, 1, 1)
FIELD(CTRL, SELEXTCLK, 2, 1)
FIELD(CTRL, IRQEN, 3, 1)
REG32(VALUE, 4)
REG32(RELOAD, 8)
REG32(INTSTATUS, 0xc)
FIELD(INTSTATUS, IRQ, 0, 1)
REG32(PID4, 0xFD0)
REG32(PID5, 0xFD4)
REG32(PID6, 0xFD8)
REG32(PID7, 0xFDC)
REG32(PID0, 0xFE0)
REG32(PID1, 0xFE4)
REG32(PID2, 0xFE8)
REG32(PID3, 0xFEC)
REG32(CID0, 0xFF0)
REG32(CID1, 0xFF4)
REG32(CID2, 0xFF8)
REG32(CID3, 0xFFC)
/* PID/CID values */
static const int timer_id[] = {
0x04, 0x00, 0x00, 0x00, /* PID4..PID7 */
0x22, 0xb8, 0x1b, 0x00, /* PID0..PID3 */
0x0d, 0xf0, 0x05, 0xb1, /* CID0..CID3 */
};
static void cmsdk_apb_timer_update(CMSDKAPBTIMER *s)
{
qemu_set_irq(s->timerint, !!(s->intstatus & R_INTSTATUS_IRQ_MASK));
}
static uint64_t cmsdk_apb_timer_read(void *opaque, hwaddr offset, unsigned size)
{
CMSDKAPBTIMER *s = CMSDK_APB_TIMER(opaque);
uint64_t r;
switch (offset) {
case A_CTRL:
r = s->ctrl;
break;
case A_VALUE:
r = ptimer_get_count(s->timer);
break;
case A_RELOAD:
r = ptimer_get_limit(s->timer);
break;
case A_INTSTATUS:
r = s->intstatus;
break;
case A_PID4 ... A_CID3:
r = timer_id[(offset - A_PID4) / 4];
break;
default:
qemu_log_mask(LOG_GUEST_ERROR,
"CMSDK APB timer read: bad offset %x\n", (int) offset);
r = 0;
break;
}
trace_cmsdk_apb_timer_read(offset, r, size);
return r;
}
static void cmsdk_apb_timer_write(void *opaque, hwaddr offset, uint64_t value,
unsigned size)
{
CMSDKAPBTIMER *s = CMSDK_APB_TIMER(opaque);
trace_cmsdk_apb_timer_write(offset, value, size);
switch (offset) {
case A_CTRL:
if (value & 6) {
/* Bits [1] and [2] enable using EXTIN as either clock or
* an enable line. We don't model this.
*/
qemu_log_mask(LOG_UNIMP,
"CMSDK APB timer: EXTIN input not supported\n");
}
s->ctrl = value & 0xf;
if (s->ctrl & R_CTRL_EN_MASK) {
ptimer_run(s->timer, ptimer_get_limit(s->timer) == 0);
} else {
ptimer_stop(s->timer);
}
break;
case A_RELOAD:
/* Writing to reload also sets the current timer value */
if (!value) {
ptimer_stop(s->timer);
}
ptimer_set_limit(s->timer, value, 1);
if (value && (s->ctrl & R_CTRL_EN_MASK)) {
/*
* Make sure timer is running (it might have stopped if this
* was an expired one-shot timer)
*/
ptimer_run(s->timer, 0);
}
break;
case A_VALUE:
if (!value && !ptimer_get_limit(s->timer)) {
ptimer_stop(s->timer);
}
ptimer_set_count(s->timer, value);
if (value && (s->ctrl & R_CTRL_EN_MASK)) {
ptimer_run(s->timer, ptimer_get_limit(s->timer) == 0);
}
break;
case A_INTSTATUS:
/* Just one bit, which is W1C. */
value &= 1;
s->intstatus &= ~value;
cmsdk_apb_timer_update(s);
break;
case A_PID4 ... A_CID3:
qemu_log_mask(LOG_GUEST_ERROR,
"CMSDK APB timer write: write to RO offset 0x%x\n",
(int)offset);
break;
default:
qemu_log_mask(LOG_GUEST_ERROR,
"CMSDK APB timer write: bad offset 0x%x\n", (int) offset);
break;
}
}
static const MemoryRegionOps cmsdk_apb_timer_ops = {
.read = cmsdk_apb_timer_read,
.write = cmsdk_apb_timer_write,
.endianness = DEVICE_LITTLE_ENDIAN,
};
static void cmsdk_apb_timer_tick(void *opaque)
{
CMSDKAPBTIMER *s = CMSDK_APB_TIMER(opaque);
if (s->ctrl & R_CTRL_IRQEN_MASK) {
s->intstatus |= R_INTSTATUS_IRQ_MASK;
cmsdk_apb_timer_update(s);
}
}
static void cmsdk_apb_timer_reset(DeviceState *dev)
{
CMSDKAPBTIMER *s = CMSDK_APB_TIMER(dev);
trace_cmsdk_apb_timer_reset();
s->ctrl = 0;
s->intstatus = 0;
ptimer_stop(s->timer);
/* Set the limit and the count */
ptimer_set_limit(s->timer, 0, 1);
}
static void cmsdk_apb_timer_init(Object *obj)
{
SysBusDevice *sbd = SYS_BUS_DEVICE(obj);
CMSDKAPBTIMER *s = CMSDK_APB_TIMER(obj);
memory_region_init_io(&s->iomem, obj, &cmsdk_apb_timer_ops,
s, "cmsdk-apb-timer", 0x1000);
sysbus_init_mmio(sbd, &s->iomem);
sysbus_init_irq(sbd, &s->timerint);
}
static void cmsdk_apb_timer_realize(DeviceState *dev, Error **errp)
{
CMSDKAPBTIMER *s = CMSDK_APB_TIMER(dev);
QEMUBH *bh;
if (s->pclk_frq == 0) {
error_setg(errp, "CMSDK APB timer: pclk-frq property must be set");
return;
}
bh = qemu_bh_new(cmsdk_apb_timer_tick, s);
s->timer = ptimer_init(bh,
PTIMER_POLICY_WRAP_AFTER_ONE_PERIOD |
PTIMER_POLICY_TRIGGER_ONLY_ON_DECREMENT |
PTIMER_POLICY_NO_IMMEDIATE_RELOAD |
PTIMER_POLICY_NO_COUNTER_ROUND_DOWN);
ptimer_set_freq(s->timer, s->pclk_frq);
}
static const VMStateDescription cmsdk_apb_timer_vmstate = {
.name = "cmsdk-apb-timer",
.version_id = 1,
.minimum_version_id = 1,
.fields = (VMStateField[]) {
VMSTATE_PTIMER(timer, CMSDKAPBTIMER),
VMSTATE_UINT32(ctrl, CMSDKAPBTIMER),
VMSTATE_UINT32(value, CMSDKAPBTIMER),
VMSTATE_UINT32(reload, CMSDKAPBTIMER),
VMSTATE_UINT32(intstatus, CMSDKAPBTIMER),
VMSTATE_END_OF_LIST()
}
};
static Property cmsdk_apb_timer_properties[] = {
DEFINE_PROP_UINT32("pclk-frq", CMSDKAPBTIMER, pclk_frq, 0),
DEFINE_PROP_END_OF_LIST(),
};
static void cmsdk_apb_timer_class_init(ObjectClass *klass, void *data)
{
DeviceClass *dc = DEVICE_CLASS(klass);
dc->realize = cmsdk_apb_timer_realize;
dc->vmsd = &cmsdk_apb_timer_vmstate;
dc->reset = cmsdk_apb_timer_reset;
dc->props = cmsdk_apb_timer_properties;
}
static const TypeInfo cmsdk_apb_timer_info = {
.name = TYPE_CMSDK_APB_TIMER,
.parent = TYPE_SYS_BUS_DEVICE,
.instance_size = sizeof(CMSDKAPBTIMER),
.instance_init = cmsdk_apb_timer_init,
.class_init = cmsdk_apb_timer_class_init,
};
static void cmsdk_apb_timer_register_types(void)
{
type_register_static(&cmsdk_apb_timer_info);
}
type_init(cmsdk_apb_timer_register_types);