The Aspeed AST2400 soc includes a static memory controller for the BMC which supports NOR, NAND and SPI flash memory modules. This controller has two modes : the SMC for the legacy interface which supports only one module and the FMC for the new interface which supports up to five modules. The AST2400 also includes a SPI only controller used for the host firmware, commonly called BIOS on Intel. It can be used in three mode : a SPI master, SPI slave and SPI pass-through Below is the initial framework for the SMC controller (FMC mode only) and the SPI controller: the sysbus object, MMIO for registers configuration and controls. Each controller has a SPI bus and a configurable number of CS lines for SPI flash slaves. The differences between the controllers are small, so they are abstracted using indirections on the register numbers. Only SPI flash modules are supported. Signed-off-by: Cédric Le Goater <clg@kaod.org> Message-id: 1467138270-32481-7-git-send-email-clg@kaod.org Reviewed-by: Peter Maydell <peter.maydell@linaro.org> [PMM: added one missing error_propagate] Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
9 lines
285 B
Makefile
9 lines
285 B
Makefile
common-obj-$(CONFIG_PL022) += pl022.o
|
|
common-obj-$(CONFIG_SSI) += ssi.o
|
|
common-obj-$(CONFIG_XILINX_SPI) += xilinx_spi.o
|
|
common-obj-$(CONFIG_XILINX_SPIPS) += xilinx_spips.o
|
|
common-obj-$(CONFIG_ASPEED_SOC) += aspeed_smc.o
|
|
|
|
obj-$(CONFIG_OMAP) += omap_spi.o
|
|
obj-$(CONFIG_IMX) += imx_spi.o
|