/************************************************************************* * wanpipe_cfg_def.h * * * * WANPIPE(tm) Wanpipe Global configuration defines * * * * Author: Alex Feldman * *=======================================================================* * Aug 27, 2008 Alex Feldman Initial version * * * *************************************************************************/ #ifndef __WANPIPE_CFG_DEF_H__ # define __WANPIPE_CFG_DEF_H__ #if defined(__WINDOWS__) #define WAN_IFNAME_SZ 128 /* max length of the interface name */ #else #define WAN_IFNAME_SZ 15 /* max length of the interface name */ #endif #define WAN_DRVNAME_SZ WAN_IFNAME_SZ /* max length of the link driver name */ #define WAN_ADDRESS_SZ 31 /* max length of the WAN media address */ typedef enum { RFC_MODE_BRIDGED_ETH_LLC = 0, RFC_MODE_BRIDGED_ETH_VC = 1, RFC_MODE_ROUTED_IP_LLC = 2, RFC_MODE_ROUTED_IP_VC = 3, RFC_MODE_RFC1577_ENCAP = 4, RFC_MODE_PPP_LLC = 5, RFC_MODE_PPP_VC = 6, RFC_MODE_STACK_VC = 7 } RFC_MODE; /* 'state' defines */ enum wan_states { WAN_UNCONFIGURED, /* link/channel is not configured */ WAN_DISCONNECTED, /* link/channel is disconnected */ WAN_CONNECTING, /* connection is in progress */ WAN_CONNECTED, /* link/channel is operational */ WAN_LIMIT, /* for verification only */ WAN_DUALPORT, /* for Dual Port cards */ WAN_DISCONNECTING, WAN_FT1_READY /* FT1 Configurator Ready */ }; enum { WAN_LOCAL_IP, WAN_POINTOPOINT_IP, WAN_NETMASK_IP, WAN_BROADCAST_IP }; /* Defines for UDP PACKET TYPE */ #define UDP_PTPIPE_TYPE 0x01 #define UDP_FPIPE_TYPE 0x02 #define UDP_CPIPE_TYPE 0x03 #define UDP_DRVSTATS_TYPE 0x04 #define UDP_INVALID_TYPE 0x05 #define UDPMGMT_UDP_PROTOCOL 0x11 /* Command return code */ #define WAN_CMD_OK 0 /* normal firmware return code */ #define WAN_CMD_TIMEOUT 0xFF /* firmware command timed out */ /* FIXME: Remove these 2 defines (use WAN_x) */ #define CMD_OK 0 /* normal firmware return code */ #define CMD_TIMEOUT 0xFF /* firmware command timed out */ /* UDP Packet Management */ #define UDP_PKT_FRM_STACK 0x00 #define UDP_PKT_FRM_NETWORK 0x01 #define WAN_UDP_FAILED_CMD 0xCF #define WAN_UDP_INVALID_CMD 0xCE #define WAN_UDP_TIMEOUT_CMD 0xAA #define WAN_UDP_INVALID_NET_CMD 0xCD /* Maximum interrupt test counter */ #define MAX_INTR_TEST_COUNTER 100 #define MAX_NEW_INTR_TEST_COUNTER 5 /* Critical Values for RACE conditions*/ #define CRITICAL_IN_ISR 0xA1 #define CRITICAL_INTR_HANDLED 0xB1 /* Card Types */ #define WANOPT_S50X 1 #define WANOPT_S51X 2 #define WANOPT_ADSL 3 #define WANOPT_AFT 4 #define WANOPT_AFT104 5 #define WANOPT_AFT300 6 #define WANOPT_AFT_ANALOG 7 #define WANOPT_AFT108 8 #define WANOPT_AFT_X 9 #define WANOPT_AFT102 10 #define WANOPT_AFT_ISDN 11 #define WANOPT_AFT_56K 12 #define WANOPT_AFT101 13 #define WANOPT_AFT_SERIAL 14 #define WANOPT_USB_ANALOG 15 #define WANOPT_AFT600 16 #define WANOPT_AFT601 17 #define WANOPT_AFT_GSM 18 #define WANOPT_AFT610 19 #define WANOPT_AFT116 20 #define WANOPT_T116 21 /* * Configuration options defines. */ /* general options */ #define WANOPT_OFF 0 #define WANOPT_ON 1 #define WANOPT_NO 0 #define WANOPT_YES 1 #define WANOPT_SIM 2 /* interface options */ #define WANOPT_RS232 0 #define WANOPT_V35 1 #define WANOPT_X21 3 /* data encoding options */ #define WANOPT_NRZ 0 #define WANOPT_NRZI 1 #define WANOPT_FM0 2 #define WANOPT_FM1 3 /* line idle option */ #define WANOPT_IDLE_FLAG 0 #define WANOPT_IDLE_MARK 1 /* link type options */ #define WANOPT_POINTTOPOINT 0 /* RTS always active */ #define WANOPT_MULTIDROP 1 /* RTS is active when transmitting */ /* clocking options */ #define WANOPT_EXTERNAL 0 #define WANOPT_INTERNAL 1 #define WANOPT_RECOVERY 2 /*Uses another oscillator(to be put by hw guys) to */ /*generate almost exactly baud rate 64333 and dividor 2*/ /* station options */ #define WANOPT_DTE 0 #define WANOPT_DCE 1 #define WANOPT_SECONDARY 0 #define WANOPT_PRIMARY 1 /* connection options */ #define WANOPT_PERMANENT 0 /* DTR always active */ #define WANOPT_SWITCHED 1 /* use DTR to setup link (dial-up) */ #define WANOPT_ONDEMAND 2 /* activate DTR only before sending */ /* ASY Mode Options */ #define WANOPT_ONE 1 #define WANOPT_TWO 2 #define WANOPT_ONE_AND_HALF 3 #define WANOPT_NONE 0 #define WANOPT_ODD 1 #define WANOPT_EVEN 2 /* ATM sync options */ #define WANOPT_AUTO 0 #define WANOPT_MANUAL 1 #define WANOPT_DSP_HPAD 0 #define WANOPT_DSP_TPAD 1 /* SS7 options */ #define WANOPT_SS7_FISU 0 #define WANOPT_SS7_LSSU 1 #define WANOPT_SS7_MODE_128 0 #define WANOPT_SS7_MODE_4096 1 #define WANOPT_SS7_FISU_128_SZ 3 #define WANOPT_SS7_FISU_4096_SZ 6 /* CHDLC Protocol Options */ /* DF Commmented out for now. #define WANOPT_CHDLC_NO_DCD IGNORE_DCD_FOR_LINK_STAT #define WANOPT_CHDLC_NO_CTS IGNORE_CTS_FOR_LINK_STAT #define WANOPT_CHDLC_NO_KEEPALIVE IGNORE_KPALV_FOR_LINK_STAT */ /* SS7 options */ #define WANOPT_SS7_ANSI 1 #define WANOPT_SS7_ITU 2 #define WANOPT_SS7_NTT 3 /* Port options */ #define WANOPT_PRI 0 #define WANOPT_SEC 1 /* read mode */ #define WANOPT_INTR 0 #define WANOPT_POLL 1 #define WANOPT_TTY_SYNC 0 #define WANOPT_TTY_ASYNC 1 /* RBS Signalling Options */ #define WAN_RBS_SIG_A 0x01 #define WAN_RBS_SIG_B 0x02 #define WAN_RBS_SIG_C 0x04 #define WAN_RBS_SIG_D 0x08 /* Front End Ref Clock Options */ #define WANOPT_FE_OSC_CLOCK 0x00 #define WANOPT_FE_LINE_CLOCK 0x01 #define WANOPT_NETWORK_SYNC_OUT 0x00 #define WANOPT_NETWORK_SYNC_IN 0x01 #define WAN_CLK_OUT_OSC 0x03 #define WAN_CLK_OUT_LINE 0x04 #define WAN_CLK_IN_8000HZ 0x05 #define WAN_CLK_IN_2000HZ 0x06 #define WAN_CLK_IN_1500HZ 0x07 #define WANOPT_HW_PORT_MAP_DEFAULT 0 #define WANOPT_HW_PORT_MAP_LINEAR 1 enum { WANOPT_OCT_CHAN_OPERMODE_NORMAL, WANOPT_OCT_CHAN_OPERMODE_SPEECH, WANOPT_OCT_CHAN_OPERMODE_NO_ECHO, }; #endif /* __WANPIPE_CFG_DEF_H__ */